|
|
 |
|
OTHER NETCAM SETUP HELP ,
SEE Links BELOW
MOST PEOPLE ARE HAVING PROBLEMS WITH THEIR FIREWALLS. WINDOWS
FIREWALL WORKS FINE IF ENABLED.
Note: IF YOU ARE RUNNING MCFEE SECURITY CENTER (FIREWALL, INTERNET & NETWORK PROTECTION, ETC.........Go To McFee Security Settings Help Page via the link below
WINDOWS FIREWALL SETTINGS, HELP PAGE CLICK HERE
Additional HELP with Netcam (under construction)
The rest of the current page (scroll down) deals with ActiveX Control which
Netcam requires.
|
|
_____________________________________________________________________________________________________________ ActiveX
CONTROL SETTINGS
The NetCam startup window may ask you for ACTIVE X control. If you see a
box with a small x in it, click on the box with an x in it, and if prompted, CLICK on
Install ActiveX ______________________________________________________________________________
If
the picture still does not work after ActiveX is installed, you may have to change some settings in the Internet Explorer
browser:
SEE "To Configure ActiveX in Internet Explorer", below
WebMaster
NOTE: If you see the message ActiveX is not supported, then your browser does not recognize ActiveX at all.
Netscape, Opera, or some other browsers other than Internet Explorer usually do not support ActiveX. In my opinion,
you can get a much better Web Browser online, free. I have used AVANT BROWSER which you can download FREE at http://www.avantbrowser.com/download.html. This browser will usually NOT have the same troubles, not to mention, the security problems you are faced with using
Internet Explorer.
Additional Active-X Configuration in Internet Explorer
1.
At the upper right hand side of your current browser Open the <Tools> menu
|
|
|
|
|
|
The Internet zone will be selected
by default
Choose one of the following paths:
-Use your mouse
to move the slider bar up and down to change your security
level
-Click <Custom Level> and select each security setting individually
|
|
|
|
|
Scroll down to ActiveX controls
and plugins
ENABLE "Allow previously unused ActiveX controls to run without prompt
DISABLE "Automatic
prompting for ActiveX controls
When you are done, Click OK twice to exit Tools menu
Go back to top of this page for links to pages with help on firewalls, port forwarding, etc.
|
|
|
|
